Wall Mount Frame Only 

This aluminum wall mount frame is great for holding one or two 12v pumps. 

Intended to mount in a van, on a flat bed truck or trailer, the aluminum frame wont rust and is bleach safe.

Rivnuts are installed for easy installation of electrical equipment, breaker switches and pump controllers. 

Picture on right is one configuration of the wall mount for RODI setup. (components not included)

See the RODI Kit here:

Soft Wash configuration:

This plate works perfectly for a soft wash application. 

Aluminum is SH safe and wont rust. 

Optional bracket add on to mount soft wash metering system to this frame. 

(components are not included)

See the Soft Wash RODI Kit here:

The plate dimensions are:

21in wide by 12in high,

• The holes in the corner are 18in wide 1.5in in from the edge on the long side
• The center hole is 10.5 in in from the edge on the long side
• The holes are 11in apart on the short side.

The installation needs 4 to 5 inches above and below the plate to accommodate the pumps and allow for clearance of the hose connections. So a 22 wide by 22 high dedicated space would be sufficient

The plate dimensions are:

21in wide by 12in high,

• The holes in the corner are 18in wide 1.5in in from the edge on the long side
• The center hole is 10.5 in in from the edge on the long side
• The holes are 11in apart on the short side.

The installation needs 4 to 5 inches above and below the plate to accommodate the pumps and allow for clearance of the hose connections. So a 22 wide by 22 high dedicated space would be sufficient